Po Ly Gim Diamond 20 CSB II/III Series

Machine Features Cross travel sub-spindle: Cross travel sub-spindle design. The main and sub spindles can work either one at a time or simultaneously for reduced machining duration. This design brings multi-function front and rear machining. Short remnant material: With the optional rough material bushing, the remnant material can be 50mm (depending on the part length). Raw material machining: 0.1mm material tolerance can be achieved by using the Rough material bushing. Replaceable fixed / Driven toolholder set: The 4 pc back stationary / driven tool holder is replaced by the newly designed replaceable fixed tool holder or driven tool holder. This enables increased tooling fiexibility. --------------------------------------------------------------- --------------------------------------------------------------- Swiss Lathe Machine Examples: 6 pcs cross working driven tool holder 4 pcs ID stationary tool holder 3 pcs front working driven tool holder 3 pcs back working driven tool holder 4 pcs back ID stationary tool holder 4 pcs back ID stationary / working driven tool holder 6 pcs OD turning tool holder (42Type with5 pcs OD turning tool) --------------------------------------------------------------- --------------------------------------------------------------- Using Live Bushing with Guide Bush Remnant Material 150 mm Using Rough Material Bushing without Guide Bush Remnant Material 50 mm Standard Accessories: - Controller: Mitsubishi - Main spindle - Back spindle - Work light - Coolant system - Part off detective sensor - Fixed bushing (Except 32B Ⅱ/ 32CSB Ⅱ/ 42B Ⅱ/ 42 CSB Ⅱ) - Live bushing - Part catcher - 6 pcs OD turning tool holder(42 Type with5 pcs OD turning tool) - 4 pcs ID stationary tool holder - 6 pcs cross working driven tool holder - 3 pcs front working driven tool holder - 4 pcs back ID stationary tool holder - 3 pcs back working driven tool holder - 4 pcs back ID stationary / working driven tool holder Optional Accessories: - Controller: Fanuc - CS axis - Rough material bushing(without guide bush) - Chip conveyor + bucket - 2 pcs front ID stationary tool holder - (available for B III / CSB III with belt type) - Y2 Axis --------------------------------------------------------------- * We reserve the rights to change the specs below without any prior notification.