Dreis & Krump "CHICAGO" Model HBP 8187-6

Please find attached a formal proposal #F-012523-2 that answers all your questions on the HBP8187-6. They don't rate these machines by tonnage but by capacity which is 3/16" full-length mild steel or 11 Ga. Stainless. We also offer the HBP8250-6 which is the next heavier rated machine at 1/4" mild steel. Please note there is an NC back gauge option that replaces the standard rack and pinion back gauge and is quoted in the proposal as well. These are beautiful machines with ground-finish nose bars, touchscreen control, and an excellent track record. Below is a link to a little demo video I did just last week on a 10' version of this machine with all the same features and covers everything from setup to basic operation.
That PB8187 is a really old mechanical rack-driven standard nose bar power leaf brake with 8' X 3/16" capacity.
We made quite a few in the '70s - 2000 but we now only have the Taiwan equivalent machine Model HSB8187.
The HSB8187 is better in so many ways. I've attached a quote for the HSB8187 Standard and the Box & Pan version HBP8187.
These are really nice machines with a great reliability record. We have had three of these machines making coffins 3 shifts for the last 8 years
at a company and they are thrilled with them. Attached is a video of the 1/4" model Box & Pan.

STANDARD EQUIPMENT

Removable Nose Bars Angle Bar
Bolted Bottom Bar 1-3/16” Insert Bar
Compact Hydraulic Power Unit Oil Level Sight Gauge
Schneider Control Panel Features:
On/Off Selector Switch Motor Start Pushbutton
Bending Leaf Up/Down Pushbuttons Emergency Stop P/B
Clamp/Unclamp Pushbuttons Automatic Cycle
ELECTRIC FOOT SWITCH – Clamps & Unclamps Top Leaf. Allows
operator mobility when loading and unloading material. Bend leaf UP
switch.

BEND ANGLE NC ADJUSTMENT – Program bend angle or read bend
angle when bending leaf is in motion.
MATERIAL THICKNESS DIAL ADJUSTMENT – Reference scale for
speedier set up when adjusting clamping pressure.
ADJUSTABLE CLAMP PRESSURE - Reduces marking on material.
BACK GAUGE – 24” travel, rack & pinion type gauge with hand wheel
adjustment on right side of machine. Inch/Cm. Scale.
MANUAL CONTROL – Bending leaf up/down pushbuttons allow operator
control of the bending leaf motion.
AUTO CYCLE – Actuate the “Auto Pushbutton” clamp the top leaf,
Angle Start raises the bending leaf to the preset bend angle setting,
lowers the bending leaf, unclamp the top leaf.
ELECTRICAL EQUIPMENT

One 7.5 H.P. general purpose motor with direct mount hydraulic pump
for operation on 220 volts, 3 PH, 60HZ with 110 volt control circuit.